4Pin Gapless Strip to Wire Connector for Waterproof RGB LED Strip Lights

4Pin Gapless Strip to Wire Connector for Waterproof RGB LED Strip Lights

Strip End:

1. cut the strip straight perfectly, then fully open the clip.

2. push the strip in until it hits the backing, and pins on the connector make contact,and press hard down for several times with nose pliers to make sure the PINS puncture through the strips.

Wire End:

1. have to be separated the 4 wires before you insert them into the connector.

2. required to press down hard for several times with nose pliers! Ensure the contacts pierces through the insulation on the wire as there are so many non-standard wires on the market!

3. reminder: no stripping of the wires. Just be sure polarity nodes are matched up "+" to "+" and "-" to "-".

If you have any problem about installation, pls feel free to contact me.